Nissan Maxima Service and Repair Manual: Headlamp

Description

Headlamp lighting when theft warning system is in alarm phase.

Component Function Check

1.CHECK HEADLAMP OPERATION

Check if headlamps operate by lighting switch.

Diagnosis Procedure

1.CHECK HEADLAMP OPERATION

Refer to EXL-6, "Work Flow" (xenon type) or EXL-171, "Work Flow" (halogen type).

2.CHECK INTERMITTENT INCIDENT

Refer to GI-41, "Intermittent Incident".

 Inspection End.

    Horn
    Description Horn (high/low) is located inside of front bumper and operates when theft warning system is in alarm phase. Component Function Check 1.CHECK FUNCTION  Select HORN in "ACTI ...

    Warning lamp
    Description  Warning lamp is built in combination meter.  Intelligent Key system malfunction is reported to the driver by the warning lamp illumination. Component Fun ...

    Other materials:

    Checking engine oil level
    1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature. 3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dipstick and wipe it clean. Rei ...

    P0776 pressure control solenoid B
    Description The secondary pressure solenoid valve regulates the secondary pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after ...

    Inspection and adjustment
    REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITION ADJUSTMENT REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITION ADJUSTMENT : Description Adjust the center position of the possible route line of the rear view monitor if it is shifted. REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITIO ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.015