Description
Warning lamp is built in combination meter.
Intelligent Key system malfunction is reported to the driver by the warning lamp illumination.
Component Function Check
1.CHECK FUNCTION
Perform "INDICATOR" in the "Active Test" mode with CONSULT.
Check warning lamp operation.

Diagnosis Procedure
1.CHECK "COMBINATION METER."
Check combination meter function. Refer to MWI-4, "Work Flow".
2.CHECK INTERMITTENT INCIDENT
Refer to GI-41, "Intermittent Incident".
Inspection End.
Headlamp
Vehicle security indicatorDisassembly and assembly
FUEL LEVEL SENSOR UNIT
Disassembly and Assembly
Fuel Level Sensor Unit
Harness connectors
Fuel level sensor unit
Fuel tank temperature sensor
Float arm assembly
Disassembly
NOTE: Before disassembly, note the proper
placement of the wires to the correct terminals a ...
TCM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (unit side and connector
side).
TCM
Harness connector F1
Harness con ...
Service data and specifications (SDS)
General Specification (Rear)
Wheel Alignment (Unladen*1)
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions. *2: 18" tire. *3: 19"
tire.
Ball Joint
Wheelarch Height (Unladen*1)
*1: Fuel, engine coolant, and lub ...