Nissan Maxima Owners Manual: Automatic drive positioner (if so equipped)

Outside mirrors

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position. Move the small switch 1 to select the right or left mirror. Adjust each mirror to t ...

Memory Storage Function (Key-Link)

Use the following process to setup key-link: 1. Unlock the vehicle with the desired Intelligent Key while the ignition is OFF. 2. Place the ignition in the ON position. 3. Within the "Sett ...

Other materials:

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal ...

Camshaft
Exploded View Camshaft position sensor bracket (RH) Camshaft brackets No. 1 camshaft bracket (RH) Camshaft (EXH) (RH) Camshaft (INT) (RH) Cylinder head (RH) Cylinder head (LH) Camshaft (EXH) (LH) Camshaft (INT) (LH) No. 1 camshaft bracket (LH) Camshaft brackets Cam ...

RGB area (YS) signal circuit
Description Transmits the display area of RGB image displayed by AV control unit with RGB area (YS) signal to display unit. Diagnosis Procedure 1.CHECK CONTINUITY RGB AREA (YS) SIGNAL CIRCUIT Turn ignition switch OFF. Disconnect display unit connector M141 and AV control unit con ...