Nissan Maxima Service and Repair Manual: M&A branch line circuit

DLC branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the terminals and connec ...

AV branch line circuit

Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the AV control unit for d ...

Other materials:

P050A, P050e cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A or P050E is dis ...

Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description MEMORY RESET PROCEDURE Please observe the following instructions at confirming the sunroof operation. NOTE: Do not disconnect the electronic power while the sunroof is operating or ...

Rear view camera
Removal and Installation REMOVAL Remove the license plate finisher. Refer to EXL-166, "Removal and Installation". Remove trunk lid finisher. Refer to INT-36, "Exploded View". Disconnect the rear view camera connector (B), press the rear view camera tab (A) and remo ...