Nissan Maxima Service and Repair Manual: Removal and installation

Preparation

PREPARATION Special Service Tools Commercial Service Tools ...

Combination meter

Removal and Installation REMOVAL  Disconnect the negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)".  Remove the cluster lid A. Refer to IP-16 ...

Other materials:

P1611 ID discord, IMMU-ECM
Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal ...

On board refueling vapor recovery (ORVR)
Description From the beginning of refueling, the air and vapor inside the fuel tank go via the refueling EVAP vapor cut valve and EVAP/ORVR line to the EVAP canister. The vapor is absorbed by the EVAP canister and the air is released to the atmosphere. When the refueling has reached ...