Nissan Maxima Service and Repair Manual: Diagnosis system (BCM)

BUZZER

BUZZER : CONSULT Function (BCM - BUZZER)

DATA MONITOR

ACTIVE TEST

    Diagnosis system (meter)
    Diagnosis Description SELF-DIAGNOSIS MODE Odo/trip meter and information display segment operation can be checked in self-diagnosis mode. Meters/gauges can be checked in self-diagnosis mode. ...

    DTC/circuit diagnosis
    POWER SUPPLY AND GROUND CIRCUIT COMBINATION METER COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-87, "Wiring Diagram". 1.CHECK FUSES Check for blown co ...

    Other materials:

    VDC/TCS/ABS
    Symptom Table If ABS warning lamp, SLIP indicator lamp turn ON, perform self-diagnosis. NOTE:  1: The ABS does not operate when the speed is 10 km/h (6 MPH) or less.  2: Under the following conditions, ABS is activated and vibration is felt when brake pedal is lightly dep ...

    Headlamp (LO) circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM over the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 51 and 52, located in the IPDM E/R. Power then flows ...

    P0300, P0301, P0302, P0303, P0304, P0305, P0306 misfire
    DTC Logic DTC DETECTION LOGIC When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is occurring. The misfire detection logic consists of the followin ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2021 Copyright www.nimainfo.com
    0.0145