Nissan Maxima Service and Repair Manual: Basic inspection

Rear view camera
Removal and Installation REMOVAL Remove the license plate finisher. Refer to EXL-166, "Removal and Installation". Remove trunk lid finisher. Refer to INT-36, "Exploded View". Disconnect ...

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW\ 1.CHECK SYMPTOM Check the malfunction symptoms by performing the following items. Interview the customer to obtain the malfunction information (c ...

Other materials:

P0101 MAF sensor
Description   The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is ...

Headlamp (HI) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 48 and 49, located in the IPDM E/R. Power then flow ...

Both side headlamps do not switch to high beam
Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION Check the combination switch (lighting and turn signal switch). 2.CHECK HEADLAMP (HI) ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.01