Nissan Maxima Service and Repair Manual: EVAP canister vent control valve

EVAP canister

Removal and Installation (EVAP Canister) EVAP control system pressure sensor EVAP canister O-ring  EVAP canister vent control valve O-ring NOTE: The EVAP canister vent contr ...

EVAP control system pressure sensor

Removal and Installation REMOVAL  Remove rear stabilizer bar clamps and position rear stabilizer bar aside. Refer to RSU-13, "Removal and Installation".  Disconnect EVAP hose from ...

Other materials:

P1800 vias control solenoid valve 1
Description The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for power valve 1 control. It responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...

Instrument Panel
Vent Headlight/fog light/turn signal switch Supplemental front-impact air bag. Horn Meters and gauges. Warning and indicator lights. Vehicle information display Paddle shifters (if so equipped) Wiper and washer switch Audio controls*. Navigation controls* Hazard warning flash ...

DTC/circuit diagnosis
POWER SUPPLY AND GROUND CIRCUIT COMBINATION METER COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-87, "Wiring Diagram". 1.CHECK FUSES Check for blown combination meter fuses. 2.POWER SUPPLY CIRCUIT CHECK Disconnect combination meter connector. ...