Nissan Maxima Service and Repair Manual: EVAP control system pressure sensor

Removal and Installation

REMOVAL

  1.  Remove rear stabilizer bar clamps and position rear stabilizer bar aside. Refer to RSU-13, "Removal and Installation".
  2.  Disconnect EVAP hose from EVAP canister.
  3.  Disconnect EVAP control system pressure sensor.
  4.  Remove EVAP control system pressure sensor and O-ring.

CAUTION: Do not reuse O-ring.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Do not reuse O-ring.

    EVAP canister vent control valve
    Removal and Installation REMOVAL  Remove rear stabilizer bar clamps and position rear stabilizer bar aside. Refer to RSU-13, "Removal and Installation".  Disconnect breather hose f ...

    Disassembly and assembly
    FUEL LEVEL SENSOR UNIT Disassembly and Assembly Fuel Level Sensor Unit Harness connectors Fuel level sensor unit  Fuel tank temperature sensor  Float arm assembly Disass ...

    Other materials:

    Inspection and adjustment
    REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITION ADJUSTMENT REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITION ADJUSTMENT : Description Adjust the center position of the possible route line of the rear view monitor if it is shifted. REAR VIEW MONITOR POSSIBLE ROUTE LINE CENTER POSITIO ...

    Climate controlled seat
    Wiring Diagram ...

    Starting the engine
    1. Apply the parking brake. 2. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift lever is in any of the driving positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ign ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0073