Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis 

System description

STARTING SYSTEM System Diagram System Description The starter motor plunger closes and provides a closed circuit between the battery and the starter motor. The starter motor is grounded to the ...

B terminal C 

Description  The "B" terminal is constantly supplied with battery power. Diagnosis Procedure  CAUTION: Perform diagnosis under the condition that the engine cannot start by the followin ...

Other materials:

Outside key antenna
REAR BUMPER REAR BUMPER : Removal and Installation REMOVAL Remove the rear bumper. Refer to EXT-17, "Removal and Installation". Disconnect harness connector (1) from the outside key antenna (rear bumper) (2). Remove the outside key antenna (rear bumper) screws (A) and ...

Front Timing Chain Case
Exploded View Intake valve timing control solenoid valve cover gasket (LH) Intake valve timing control solenoid valve cover gasket (RH) Intake valve timing control solenoid valve cover (RH) (bank 1) O-ring 5. Intake valve timing control solenoid valve (RH) with O-ring Intake valve t ...

The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform IPDM E/R auto active test. Refer to PCS-11, "Diagnosis Description". 2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT Check the oil pressure sw ...