Nissan Maxima Service and Repair Manual: P1705 TP sensor
Description
The electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor, etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT
-
Turn ignition switch ON.
-
Depress accelerator pedal fully and release it, then wait for 5 seconds.
-
Perform "Self Diagnostic Results" in "TRANSMISSION".
Diagnosis Procedure
1.CHECK DTC WITH ECM
With CONSULT
-
Turn ignition switch ON.
-
Perform "Self Diagnostic Results" in "ENGINE".
2.CHECK DTC WITH TCM
With CONSULT
Perform "Self Diagnostic Results" in "TRANSMISSION".
3.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
P1701 TCM
Description
When the power supply to the TCM is cut off, for example
because the battery is removed, and the self-diagnosis
memory function stops, a malfunction is detected.
NOTE:
Since "P1701 ...
P1709 incompleted data writing
Description
When TCM does not store calibration data (individual
characteristic value) of each solenoid valve that is
stored in the ROM assembly (in the control valve), a malfunction is detected. ...
Other materials:
P0730 incorrect gear ratio
Description
TCM selects the gear ratio using the engine load (throttle position), the
primary pulley revolution speed, and
the secondary pulley revolution speed as input signals. Then it changes the
operating pressure of the primary
pulley and the secondary pulley and changes the groove wid ...
Power supply and ground circuit
BCM
BCM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-67, "Wiring Diagram".
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blown.
Is the fuse or fusible link blown?
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
...
Blower motor control system
System Diagram
System Description
Fan speed is automatically controlled by the temperature setting, ambient
temperature, in-vehicle temperature,
intake temperature, amount of sunload and air mix door position.
By pressing the AUTO switch, the blower motor starts to gradually increase
a ...
Nissan Maxima Owners Manual
- Illustrated table of contents
- Safety-Seats, seat belts and supplemental restraint system
- Instruments and controls
- Pre-driving checks and adjustments
- Monitor, climate, audio, phone and voice recognition systems
- Starting and driving
- In case of emergency
- Appearance and care
- Do-it-yourself
- Maintenance and schedules
- Technical and consumer information
Nissan Maxima Service and Repair Manual
0.0105