Removal and Installation - Front Sensor Rotor
The front wheel sensor rotor is an integral part of the wheel hub and bearing assembly and cannot be disassembled.
Removal and Installation - Rear Sensor Rotor
The rear wheel sensor rotor is an integral part of the wheel hub and bearing assembly and cannot be disassembled.
Wheel sensors
ABS actuator and electric unit (control unit)Unexpected pedal reaction
Diagnosis Procedure
1.CHECK BRAKE PEDAL STROKE
Check brake pedal stroke.
2.CHECK FUNCTION
Disconnect ABS actuator and electric unit (control unit) connector to
deactivate ABS. Check if braking force is
normal in this condition.Connect connector after inspection.
3.CHECK WHEEL SENSOR AND SEN ...
B260A ignition relay
Description
BCM turns ON the following relays to ignition power supply to each ECU when
the ignition switch is turned
ON.
Ignition relay-1 (inside IPDM E/R)
Ignition relay-2 (inside fuse block (J/B))
Front blower motor relay
BCM checks any ignition relay ON request for consistency wi ...
P0703 brake switch B
Description
BCM detects ON/OFF state of the stop lamp switch and transmits the data to
the TCM via CAN communication
by converting the data to a signal.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION: Always drive vehicle at a safe speed.
NOTE: Immediately after perform ...