Nissan Maxima Service and Repair Manual: Removal and installation

Clip list

Descriptions for Clips Replace any clips which are damaged during removal or installation. ...

Front seat

Exploded View DRIVER Driver Seat - With Climate Controlled Seats Seatback board Seatback board clip Seat cushion lower rear finisher Seat harness Seat cushion inner finisher inside ...

Other materials:

B2601 shift position
Description BCM confirms the shift position with the following 2 signals.  CVT selector lever  P position signal from IPDM E/R (CAN) DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2601 is displayed with DTC U1000, first perform the trouble diagnosis for DTC ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Front fog lamp circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the front fog lamp relay based on inputs from the BCM over the CAN communication lines. When the front fog lamp relay is energized, power flows from the front fog lamp relay in the IPDM E/R to the front fog ...