Nissan Maxima Service and Repair Manual: Removal and installation

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELTPRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used alongwith a front ...

Front wiper

Exploded View Rib (part of wiper blade refill) Wiper blade refill Front RH wiper blade assembly (includeswiper blade refill) Front RH wiper arm Wiper arm cap Front wiper drive asse ...

Other materials:

P0453 evap control system pressure sensor
Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously ...

Push-Button Ignition Switch
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed three consecutive times in less than 1.5 seconds or the ignition switch is pushed and held for more than 2 seconds.) If the engine ...

Tire pressure receiver
Removal and Installation REMOVAL Remove instrument lower panel LH. Refer to IP-11, "Removal and Installation". Locate tire pressure receiver (1) to the right of the steering column and disconnect the harness connector from the tire pressure receiver. Remove tire pressure receiver ...