Basic inspection
Audio systemDiagnosis sensor unit
Removal and Installation
WARNING:
Before servicing, turn ignition switch OFF, disconnect both
battery terminals and wait at least 3 minutes.
Before disconnecting the air bag sensor unit harness
connector, be sure to disconnect the harness connector of each air bag
module and pre-tens ...
The fuel gauge pointer does not move
Description
Fuel gauge needle will not move from a certain position.
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
Select "METER/M&A" on CONSULT.
Using "FUEL METER" of "DATA MONITOR", compare
the monitor value with the fuel gauge reading on
the co ...
Active noise cancellation/Active sound control (if so equipped).
Active noise cancellation
Front and rear microphones
This system uses three microphones 1 located
inside the vehicle to detect engine booming
noises. The system then automatically generates
a noise canceling sound through the speakers
and woofer to reduce engine booming noise.
NOTE:
To o ...