Nissan Maxima Service and Repair Manual: ECU diagnosis information

Microphone signal circuit

Description Voice signals are transmitted from the microphone to the Bluetooth control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNI ...

Audio unit

Reference Value TERMINAL LAYOUT PHYSICAL VALUES ...

Other materials:

Line pressure test
Inspection and Judgment INSPECTION Line Pressure Test Procedure  Inspect the amount of engine oil and replenish if necessary.  Drive the car for about 10 minutes to warm it up so that the CVT fluid reaches in the range of 50 to 80C (122 to 176F). Then inspect the ...

Tire labeling
Example Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The ...

C1116 stop lamp SW
Description The stop lamp switch transmits the stop lamp switch signal (ON/OFF) to the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSIS RESULTS Check the self-diagnosis results. Diagnosis Procedure 1.CO ...