Nissan Maxima Service and Repair Manual: Removal and installation

Oil filter
Removal and Installation REMOVAL  Drain engine oil. Refer to LU-9, "Changing Engine Oil".  Remove front fender protector side cover (RH). Refer to EXT-15, "Exploded View".   ...

Oil pump
Removal and Installation REMOVAL  Remove the engine from the vehicle. Refer to EM-103, "Removal and Installation".  Remove the upper oil pan. Refer to EM-37, "Removal and Instal ...

Other materials:

Installing front license plate
Use the following steps to mount the front license plate: 1. Make holes on the plastic finisher at the location mark (small dimple) using a 5 mm (0.20 in) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. 2. Mount ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Seat memory switch
Description Seat memory switch is installed to the front door LH trim. The operation signal is input to the driver seat control unit when the seat memory switch is operated. Component Function Check 1. CHECK FUNCTION Select ""MEMORY SW 1", "MEMORY SW 2", "SET SW" in "DATA MONITOR" mode ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.0067