Inspection and adjustment
Audio systemHVAC branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the A/C auto amp. for
damage, bend and loose connection (unit
side and connector side).
2.CHECK HARNESS FOR OPEN CIRCUI ...
System maintenance
The sensor for the ICC system A is located on
the front of the vehicle.
To keep the ICC system operating properly, be
sure to observe the following:
Always keep the sensor area clean.
Do not strike or damage the areas around
the sensor. Do not touch or remove the
screw located on ...
P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Tu ...